Install Hitch; Connecting The Battery; Check/Adjust The Tire Pressure - Murray MYZ4219000 Operator's Manual

Install Hitch

To tow objects or install the grass catcher, locate the hitch
and install it on the rear of the frame using two bolts and
nuts. The bolts are to be inserted into the top face of the
frame and the nuts are to be threaded on from the bottom
as shown in Fig.6.
NOTE: Hitch and hex bolts are provided in the hardware
pack.
Fig. 6
14
Connecting the Battery
The battery is located under the operator's seat. To connect
the battery cables, proceed as follows:
1. Attach the positive cable (red) to the positive battery
terminal using the bolt and nut.
2. Attach the negative cable (black) to the negative battery
terminal using the bolt and nut.
WARNING: When attaching battery cables, always
connect the positive cable to its terminal FIRST, and then
connect the negative cable. Additionally, a protective
case is placed over the positive cable to prevent it
grounding. Always keep the protective case in place
when connecting the battery.
Fig. 7
ZERO TURN MOWER

Check/Adjust the Tire Pressure

NOTICE: To ensure that the grass is cut level, each front tire must be set to the same pressure. The same is true for
the rear tires.
Recommended tire pressure:
• Set the front tires to 20 psi
• Set the rear tires to 14 psi
20 psi
Fig. 8
ZERO TURN MOWER
14 psi
15