True TR1RRI-1S Installation Manual page 13

True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
PILASTER INSTALL/OPERATION CONTINUED...
Installation Procedures (Pilasters):
Install slotted thumb screws into threaded holes
along the inside wall of the cabinet.
Slide pilasters into position behind the slotted
screws. Leave all of the thumb screws loose for
adjustments when installing tray slides.
It is critical to measure from the center of the
square hole on the front pilaster to the center hole
of the rear pilaster. This measurement should be
24 5/8" (See Image 13). Do the same on the oppo-
site side of cabinet for single door. Make sure the
measurement (24 5/8") is the same in the center
pilasters in 2 and 3 door units. Tap the tray slides
(Critical Measurement Front to Rear Pilasters)
13
Type Kit #1 (Angle Type Tray Slide)
7
8
11
11
INSTALLATION / OPERATION INSTRUCTIONS
Type Kit #2 (Rod Style Tray Slide)
9
10
............ www.truemfg.com ............
............ www.truemfg.com ............
into the Pilasters with a rubber Mallet.
Angle & Rod Type shelving uses a 18 1/8" dis-
tance between Pilasters. Universal Tray slides have
a 21 1/4" distance between Pilasters. (See Image14).
After the pilasters are installed the Universal
Tray, Angle Type Tray, and Rod Style Tray Slides will
slide into the pilasters (See Images 7-12). When dis-
assembling or changing tray slides a rubber mallet
may be used to take out the different tray slides.
Gently tap on the under side of the tray slide to
loosen it from the pilaster.
Top view (Critical Measurement side to side)
18 1/8"
Angle Type &
Rod Type
14
Type Kit #3 (Universal Tray Slide)
11
12
21 1/4"
Universal
Tray Slide
11
11