Table of Contents
Advertisement
WARNING ‒ Risk of burns!
The cooking compartment gets very hot when the
cleaning function is in progress.
Never open the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never touch the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Note: The oven light does not light up while the clean-
ing function is running.
Requirement: → "Preparing the appliance for the
cleaning function", Page 18.
Press
.
1.
a The cleaning setting is highlighted in white.
Use the control ring to set the cleaning setting.
2.
Cleaning set-
Cleaning
ting
level
1
Low
2
Medium
3
High
Select a higher cleaning setting for heavier or older
soiling.
The duration cannot be changed.
17 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
17.1 Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
1.
Lift the rail forwards slightly
Pull the whole rail to the front
2.
Clean the rail.
3.
→ "Cleaning products", Page 16
Duration in hours
Approx. 1:15
Approx. 1:30
Approx. 2:00
and detach it
.
and remove it.
Press .
3.
a A notification stating that you should carry out the
necessary preparatory work for the cleaning func-
tion appears in the display.
Press to start.
4.
a The cleaning function starts and the duration counts
down. The heating line does not appear.
a For your safety, the appliance door locks once a
certain temperature is reached in the cooking com-
partment. appears in the display.
a When the cleaning function ends, a signal sounds
and the duration is at zero in the display.
Press
to switch the appliance off.
5.
When the appliance has cooled down, the appliance
door is unlocked and goes out.
→ "Preparing the appliance for use following the
6.
cleaning function", Page 19.
16.3 Preparing the appliance for use
following the cleaning function
Allow the appliance to cool down.
1.
Wipe off any ash that has been left behind in the
2.
cooking compartment, on the rails and around the
appliance door with a damp cloth.
Remove white residues with lemon juice.
3.
Note: White residues on the enamel surfaces may
be caused by heavy soiling. These food residues
are harmless. The deposits do not compromise the
functionality of the appliance.
17.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
First, push the rail into the middle of the rear
1.
socket until the rail rests against the cooking
compartment wall, and then push this back
Push the rail into the front socket
2.
also rests against the cooking compartment wall,
and then press this downwards
Rails en
.
until the rail
.
19
Advertisement
Table of Contents
