Table of Contents
Advertisement
TEMPERATURE CONTROL ADJUSTMENT FOR
HIGH ALTITUDE ONLY!
TERMS:
• Cut-out - Temperature sensed by the controller
that shuts the compressor off.
• Cut-in - Temperature sensed by the controller
that turns the compressor on.
TOOLS REQUIRED:
• Phillips head screwdriver
5
•
/
" or 2 mm Allen wrench
64
• T-7 Torx wrench
A. Unplug or disconnect power to the cabinet.
B. Remove the screws that secure the tempera-
ture control to the inset box, lower right, rear
of cabinet.
C. Pull out gently from cabinet.
Compressor
Connection (pink)
connect one pink wire (either one) to terminal 3 and the other pink wire to terminal 4.
14
MAINTENANCE, CARE & CLEANING
DANFOSS TEMPERATURE CONTROL
3
To wire temperature control:
............ www.truemfg.com ............
True Food Service Equipment, Inc.
NOTE
Mechanical temperature controllers are affected
when functioning at high altitude. The Cut-in and
cut-out temperatures will be colder than when the
controller functions closer to sea level.
D. For high elevation installations, it may be nec-
essary to "warm-up" the set points. To make
the adjustment, insert the appropriate tool in
each adjustment screw and turn 1/4 of a revo-
lution clockwise (to the right). This procedure
will adjust both the cut-in and cut-out about
2°F warmer.
E. Make sure to reconnect the pink wire to prop-
er spade terminal when reinstalling.
4
Cut-out Adjustment Screw
5
Allen (
/
" or 2 mm)
64
(clockwise for warmer)
Cut-in Adjustment Screw
Torx (T-7)
(clockwise for warmer)
Compressor Connection
(pink)
(double terminal)
14
Advertisement
Table of Contents
