Check on the spinning, is the frequency of the
water level 48 or more. The frequency can be
checked by pressing the [WASH] and [RINSE]
buttons at the same time on the program.
Check the sensor
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose, replace
the sensor or the hose.
Normal
YES >| Correct the connetor.
When pressing 'WASH,, "RINSE, and "POWER,
buttons at the same time after power off, press
the [START/PAUSE)]button 2 times, is the drum
low speed spin?
Is it disconnected, or disassembled?
(Natural:3pin(@),Red:4pin(@), Red:2pin(@),
Yellow:2pin(@))
Check the motor connector, is the resistance of
the terminal same as the figure?
Resistance of terminal: Q@~@:0.5~1.0 9
©-@:1.5~2.5 0
Replace the motor assy.
(4681FR1194A)
MOTOR TERMINAL
Replace the PWB assy (Main)