Advertisement
2002 Volvo C70 Coupe & Convertible
Starting and stopping
1. Fasten the seat belt.
WARNING!
Before starting, check that the seat, steering wheel and mirrors are adjusted properly. Make sure the
brake pedal can be depressed completely. Move the seat closer if necessary. Refer to section "front
seats".
2. Apply the parking brake, if not already set. The gear selector (automatic transmission) is locked in
the (P)ark position (SHIFT LOCK).
Manual transmission: the clutch must be fully depressed.
3. Without touching the accelerator pedal, turn the ignition key to the starting position*. Allow the
starter to operate for up to 10 seconds. Release the key as soon as the engine starts. If the engine fails to
start, repeat step 3.
For cold starts at altitudes above 6000 ft (1800 meters), depress the accelerator pedal halfway and turn
the key to the starting position. Release the pedal slowly when the engine starts.
4. To release the gear selector from the (P)ark position (automatic transmission), the ignition key must
be in position II and the brake pedal must be depressed. See
releasing the SHIFTLOCK system.
Do not race a cold engine immediately after starting. Oil flow may not reach some lubrication points fast
enough to prevent engine damage.
NOTE: (Automatic transmission only)
Your car is equipped with a KEYLOCK system. When the engine is switched off, the gear selector
must be in the (P)ark position before the starting key can be removed from the ignition switch.
5. Select the desired gear. The gear engages after a slight delay (automatic transmission) which is
especially noticeable when selecting R.
CAUTION: (Automatic transmission only)
The engine should be idling; never accelerate until after you feel the gear engage! Toorapid acceleration
file:///K|/ownersdocs/2002/2002_C70/02c70c_04a.htm (7 of 11)12/30/2006 3:53:53 PM
page 105
for instructions on manually
Advertisement
Chapters
