Advertisement
2002 Volvo C70 Coupe & Convertible
WARNING!
The jack's attachment must engage the bar in the jack attachment (A). The car's weight must not
rest on the jack attachment (B).
Be sure the jack is on a firm, level, non-slippery surface.
Never allow any part of your body to be extended under a car supported by a jack.
Use the jack intended for the car when replacing a wheel. For any other job, use stands to support
the side of the car being worked on. -
Apply the parking brake, select position P (automatic transmission) or Reverse gear (manual
transmission).
Block the wheels standing on the ground, use rigid wooden blocks or large stones.
The jack should be kept well-greased.
Installing the wheel
Clean the contact surfaces on the wheel and
hub. Lift the wheel and place it on the hub. Make sure that you align the wheel with the guide stud on
the wheel hub prior to installation. Install the wheel bolts crosswise (see illustration) and tighten by
turning lightly clockwise. Lower the vehicle to the ground and alternately tighten the bolts to 100 ft. lbs.
(130 Nm). Install the wheel cap (where applicable).
CAUTION: Correct tightening torque on wheel bolts must be observed. The wheel bolts should never
be greased or lubricated. The extended, chromed wheel bolts must not be used with steel rims, as they
make it impossible to fit the hub caps.
pg. 92 Spare tire
file:///K|/ownersdocs/2002/2002_C70/02c70c_06a.htm (3 of 11)12/30/2006 3:53:59 PM
Correct tightening order for wheel bolts
Advertisement
Chapters
