Fetco CBS-1261 User Manual page 17

Brewer Setup
1) Attach legs
NOTE-Assemble legs immediately after unpacking
the brewer and before connecting it to utilities
NOTE-Legs are located in brew basket
4" legs -
Part number 1073.00007.00
3 required for CBS-1262
4 required for CBS-1261
Always attach legs before installing.
Legs are sent from factory inside brew basket.
3) Attach water inlet adapter
Place rubber washer with screen in adapter. Hand tighten only-and 1/4 turn with wrench
FETCO
Inlet valve
Install the adapter on inlet valve first before attaching water line. Adapter is shipped in the brew basket
The valve threads are 3/4" BSP MALE THREAD and are not 3/4 garden hose fittings.
Use of any other connector to valve will damage the valve
DO NOT use USA dishwasher water adapter or USA washing machine adapter for this connection.
The threads on these USA adapters are unusable for the valve
TO PREVENT DAMAGE AND INSURE PROPER EQUIPMENT OPERATION
The inlet valve thread is 3/4 INCH BSP (British Standard Pipe).
This valve is not a standard USA washing machine or dishwasher thread (¾" GHT)
-Use only the plumbing adaptor kit included with this equipment. Use the gasket included in adaptor kit
-Plumber's tape is not recommended for the adapter to valve connection
-Hand tighten adapter on valve with gasket, then very lightly wrench 1/4 turn to set
-DO NOT SUBSTITUTE FITTINGS FOR CONNECTING TO WATER SUPPLY
Damage to inlet valve from improper installation will void the warranty
NOTE: DO NOT PLUMB TANK DRAIN. DRAIN IS FOR SERVICE AND MAINTENANCE.
Go to fetco.com for the latest versions of all information
Inlet valve
adapter
Rubber washer
with screen
(Included with
adapter)
Page 17
2) Verify dispenser locator
Reversible dispenser locator is user configurable
From TPD-30 (3 gal) To L4D-15 or TPD-15 (1½ gal)
90 degree 3/8" flare fitting

3/8"
This may be removed
flare fitting
and replaced with a 3/8"
compression fitting or
other connection.
¼" fnpt base
Fitting to base is ¼" NPT
Use thread sealing
plumber tape or sealant
paste on threads
User Guide & Operator instructions
TPD-30; 3 gallon
Configuration
Remove screws
Reverse locator
Refasten screws
TPD-15 or,
L4D-15
1 ½ gallon
configuration
P214 September 2023