Presetting Channels - Sony KV-25DXR Service Manual

KV-25DXR
RM-727/APM-X3U
1-5. PRESETTING CHANNELS
Controls on the TV
CABLE
ON/OFF
button
Channel number
--11-.Jr-,
buttons
ENTER button ----
Receivable channels of your set are:
VHF: 2-13
UHF: 14-69
CATV: 1-125
By adding and erasing channels, you can preset your TV
so that only the desired channels appear in sequence
when the CHANNEL+/- are pressed.
PREPARATION
1
Turn on TV.
2 Make sure the following are properly set.
On-screen "VIDEO 1, 2 or 3", "EXT-A" or "RGB" in-
dicators and the RGB or VIDEO lamp should be off.
(Press TVNIDEO button or RGB button as necessary
until they go out.)
3 According to the channel to be added or erased,
check the following and make the necessary changes
if any.
• CABLE ON/OFF button
For VHF and UHF channels, set to OFF
n.
For cable TV channels, set to ON =·
• On-screen "AUX" indicator
(Press ANT/AUX button as necessary.)
For VHF, UHF and regular cable TV channels:
The indicator should be off.
For pay cable TV channels:
The indicator should be displayed.
l
----
011 I
~---~
scan buttons
ADDING CHANNELS
1 Select the channel to be added by pressing the chan•
nel number buttons and then ENTER.
2
Press ADD.
A"+" indication will appear on the left of the chan-
nel display on the screen, indicating that the chan-
nel will appear in the proper numerical sequence
when you press CHANNEL+/-.
Repeat steps
1
and
2
for other channels to be added.
ERASING CHANNELS
1 Select the channel to be erased.
2 Press ERASE.
A"-" indication will appear on the left of the chan-
nel display on the screen, indicating that the chan-
nel has been erased. When CHANNEL +/- are
pressed, you will see that the channel is skipped
over in the numerical sequence.
Repeat steps
1
and
2
for other channels to be erased.
To add erased channels again, follow the steps in
"ADDING CHANNELS".
Note
You cannot erase a VHF or UHF channel from the
memory and retain a cable TV channel which has the
same number, or vice versa. If either a VHF/UHF chan-
nel or a cable TV channel with the same number is to be
kept in the memory, do not erase the number.
-10-
I.