Table of Contents
Advertisement
Operating/Installation Instructions and
What To Do If The Alarm Sounds
зир 4.
Peak
Level Memory
If the CO sensor has detected a CO levei of 100 PPM or
higher since last reset, it will be recorded by the Peak
Level Memory function.To access the Peak Level
Memory press the test/reset button. If a reading of 100
PPM or higher has been recorded the unit will chirp 8
|
times. If you've been away from home this feature
allows you to check if there was a CO reading of 100, or
higher, during your absence. Pushing the test/reset
button resets the memory. It's also reset when batteries
are removed.
—
What To Do If The Alarm Sounds
NEVER IGNORE THE SOUND OF THE ALARM!
Determining what type of alarm has sounded is easy
with your Nighthawk Combination Smoke/CO Alarm.
The voice message warning system will inform you of
the type of situation occurring.
Refer to the Features
section on page 4 for a detailed description of each
alarm pattern.
When the smoke alarm sounds:
Smoke alarms are designed to minimize false alarms.
Cigarette smoke will not normally set off the alarm,
}
unless the smoke is blown directly into the alarm.
Combustion particles from cooking may set off the
alarm if located too close to the cooking area. Large
quantities of combustible particles are generated from
spills or when broiling. Using the fan on a range hood
which vents to the outside (non recirculating type) will
also help remove these combustible products from the
kitchen.
16
—
Advertisement
Table of Contents
