Table of Contents
Advertisement
Operating/Installation Instructions
THIS EQUIPMENT
SHOULD
BE INSTALLED
IN
ACCORDANCE
WITH
THE NATIONAL
FIRE
PROTECTION ASSOCIATION'S STANDARD
72
(National Fire Protection Association,
Batterymarch Park, Quincy, MA 02269).
WARNING - This product is intended for
use in ordinary indoor locations of family
living units.
It is not designed to meas-
ure compliance with Occupational Safety
and Health Administration (OSHA)
commercial or industrial standards.
B. Where Not to Install:
Do not install in garages, kitchens, furnace rooms
or bathrooms!
INSTALL AT LEAST 15 FEET AWAY
FROM ANY FUEL BURNING APPLIANCE.
Do not install within 3 ft (.9m) of the following:The
door to a kitchen, or a bathroom that contains a tub or
shower, forced air ducts used for heating or cooling,
ceiling or whole house ventilating fans, or other high air
flow areas. Avoid excessively dusty, dirty or greasy areas.
Dust, grease or household chemicals can contaminate
the alarm's sensors, causing it to not operate properly.
Place the alarm where drapes or other objects will not
block the sensors. Smoke and CO must be able to reach
the sensors to accurately detect these conditions. Do
not install in peaks of vaulted ceilings, "А" frame ceilings
or gabled roofs. Keep out of damp and humid areas.
12
Advertisement
Table of Contents
