Operation; Checks Before Operation; Precautions For Moving Machine Forward Or In Reverse; Precautions When Traveling - Komatsu GALEO D65EX-15 Operation & Maintenance Manual

SAFETY

OPERATION

CHECKS BEFORE OPERATION

When carrying out the checks, move the machine to a wide area where there are no obstructions, and operate
slowly. Do not allow anyone near the machine.
Always fasten your seat belt.
Check the operation of travel, steering and brake systems, and
work equipment control system.
Check for any abnormality in the sound of the machine,
vibration, heat, smell, or gauges; check also that there is no
leakage of oil or fuel.
If any abnormality is found, carry out repairs immediately.

PRECAUTIONS FOR MOVING MACHINE FORWARD OR IN REVERSE

Before travelling, check again that there is no one in the
surrounding area, and that there are no obstacles.
Before travelling, sound the horn to warn people in the area.
Always operate the machine only when seated.
Do not allow anyone apart from the operator to ride on the
machine.
Check that the back-up alarm (alarm buzzer when machine
travels in reverse) works properly.
Fix the operator's compartment doors and windows in position
securely.
If there is an area to the rear of the machine which cannot be
seen, position a signal person. Take special care not to hit other
machines or people when turning or swinging the machine.
Always be sure to carry out the above precautions even when the machine is equipped with mirrors.

PRECAUTIONS WHEN TRAVELING

When traveling on level ground, keep the work equipment at a
height of 40 to 50 cm (16 to 20 in) from the ground.
When traveling on rough ground, travel at low speed and do not
operate the steering suddenly. There is danger that the machine
may turn over. The work equipment may hit the ground surface
and cause the machine to lose its balance, or may damage the
machine or structures in the area.
PRECAUTIONS FOR OPERATION
2 - 19