Adjusting Posture Of Work Equipment - Komatsu GALEO D65EX-15 Operation & Maintenance Manual

OPERATION

ADJUSTING POSTURE OF WORK EQUIPMENT

METHOD OF ANGLING BLADE
Angledozers only
When dozing toward one side only, operate with angled blade.
When adjusting the amount of angling, it is dangerous if the work
equipment is moved by mistake. Set the work equipment in a safe
condition, then stop the engine and lock the work equipment securely
with the work equipment lock lever.
Be careful when removing arm (2). After arm (2) is removed, the blade
can move freely.
1. Raise the blade 400 to 500 mm (15.8 to 19.7 in) above the
ground, then put blocks under the frame so that the blade does
not come down.
2. Remove pins (1) on the left and right sides, then remove arm
(2) from the frame.
WARNING
OPERATION
3 - 105