Whirlpool WOES7030P Dimension Manual page 6

DIMENSION GUIDE
Electrical Connection
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the
instructions provided for it here.
■ Oven must be connected to the proper electrical voltage and
frequency as specifi ed on the model/serial/rating plate. The
model/serial/rating plate is located under the control panel
on single ovens and under the control panel on the upper
oven cavity on double ovens. See the following illustration.
SINGLE OVEN
A. Model/serial/rating plate
■ Models rated from 7.3 to 9.6 kW at 240 V (5.4 to 7.4 kW at
208 V) require a separate 40 A circuit. Models rated at
4.8 kW and below at 240 V (3.6 kW and below at
208 V) require a separate 20 A circuit. This model requires a
separate 20 A circuit.
■ A circuit breaker is recommended.
■ Connect directly to the fused disconnect (or circuit breaker
box) through fl exible, armored or nonmetallic sheathed,
copper cable (with grounding wire). See the "Make Electrical
Connection" section in the Owner's Manual.
■ Flexible conduit from the oven should be connected directly
the junction box.
■ Fuse both sides of the line.
■ Do not cut the conduit. The length of conduit provided is for
serviceability of the oven.
■ A UL listed or CSA-approved conduit connector must be
provided.
A
■ If the house has aluminum wiring, follow the procedure
below:
Connect the aluminum wiring using special connectors
and/or tools designed and UL listed for joining copper to
aluminum.
Follow the electrical connector manufacturer's
recommended procedure. Aluminum/copper connection
must conform with local codes and industry-accepted wiring
practices.
6 of 18