Adding Laundry; Changing The Programme; Cancel The Programme; Programme End During Rinse Hold - Bosch WAK20200GB Instruction Manual And Installation Instructions

To activate/deactivate the childproof
lock, press and hold Start/Pause for
approx. five seconds. The E symbol
appears in the display panel.
E lights up: The childproof lock is
■
active.
E flashes: The childproof lock is
■
active and the programme selector
was adjusted. To prevent the
programme from stopping, turn the
programme selector back to the
original programme. The symbol
lights up again.
The childproof lock can remain
Note:
activated until you wish to start the next
programme, even after switching off the
machine.
You must then deactivate the childproof
lock before starting the programme and
activate it again as necessary once the
programme has started.

Adding laundry

After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/Pause A
button.
The Start/Reload A indicator lamp
flashes and the machine checks
whether it is possible to add laundry.
Do not leave the washing
Note:
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If the display panel shows:
Both the YES and ¼ symbols lit up,
■
it is possible to add laundry.
A flashing NO symbol, wait until YES
■
and ¼ light up.
Do not open the door until both the
YES and the ¼ symbols are lit.
A flashing NO symbol, it is not
■
possible to add laundry.
For safety reasons, the washing
machine door remains locked when
Operating the appliance
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry.
To continue the programme, press
the Start/Pause A button. The
programme continues automatically.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press Start/Pause A.
1.
Select the other programme.
2.
Press Start/Pause A. The new
3.
programme starts from the
beginning.

Cancel the programme

Programmes at high temperatures:
Press Start/Pause A
1.
To cool the laundry: Select O Rinse.
2.
Press Start/Pause A.
3.
For programmes at low temperatures:
Press Start/Pause A.
1.
Select 0 Spin or [ Empty.
2.
Press Start/Pause A.
3.
Programme end during rinse
hold
– – – 0 appears on the display panel
and the Start/Reload button indicator
lamp flashes.
To end the programme, set the
programme selector to 0 Spin /
[ Empty or select a spin speed. Then
press the Start/Pause A button.

Programme end

End appears on the display panel and
the Start/Pause button indicator lamp is
off.
If the 9 symbol appears on the display
panel, the washing machine has
en
21