Sony ICF-SW7600 Operating Instructions Manual page 8

How to Change the MW Chan nel Step
3 Change MW CH STEP.
4 Install the batteries and close the battery
compartment.
5 Set POWER/LOCK to POWER,
The MW channel step is factory-set to 9 (10) kHz to
match the frequency allocation system of the country. If
you use the radio where the frequency allocation system
is based on a 10 (9) kHz interval, set the MW CH STEP
selector in the battery compartment to 10 (9) kHz,
1 Set POWER/LOCK to LOCK.
2 Open the battery compartment and take out the
batteries.
*9
of
The frequency aliocation of the area
1 Area 1
Frequency allocation system
1 North America. South America
10 kHz step
: Other countries
9 kHz step
Notes
Chsnpe the MW CH STEP within 10 minutes
If more than 10 minutes have passed after batteries were removed, the
current time vhll be erased. In this case, set the time again.
The preset stations will be erased
When you change the MW channel step, the preset stations will be erased.
In such a case, preset the stations again.
-if-
■m