Toshiba 26AV500U Owner's Manual page 17

Connectin9 an HDMFM or DVJ
device to the HDMJinput
The HDM[ input on your TV receives digital audio and
uncompressed digital video flom an HDM[ source device,
or uncompressed digital video from a DVI (Digital Visual
[nterface) source device. This TV is able to connect with
HDMI devices. But it is possible that sltme HDMI devices
may not operate properly with this TV.
This input is designed to accept HDCP (High-Bandwidth
Digital-Content Protection) program material in digital form
from EIA/CEA-861 -D-compliant m consumer electronic
devices (such its a set-top box or DVD player with HDM[ or
DVI output).
The HDMI 1 input can accept and display VGA, SVGA,
XGA, 480i (60Hz), 48% (60Hz), 720p (60Hz), and 1080i
(60Hz) signal formats. For detailed signal specifications, see
page 49.
Supported Audio f()rmat: Linear PCM, sltmpling rate 32144. l/
48 kHz
Note: To connect a PC to the HDMI input, see page 19.
To connect an HDMI
device,
you will need:
• one HDM[ cable (type A connector) per HDM[ device
- For proper operation, it is recommended that you use an
HDMI cable with the HDMI Logo (_.._.=_[TI| ),
- To display an 1080i/60Hz signal format, you will need a
Category 2 cable, Conventional HDMI/DVI cable may
not work properly,
- HDMI cable transfers both video and audio, Separate
analog audio cables are not required (see illustration),
HDIVll device
To view the HDMI device video:
Select the HDMI 1 or HDM[ 2 video input source on the TV.':_
To select the video input source, press INPUT on the remote
control (_> page 21). To program the TV remote centre] to operate
other devices, see Chapter 3.
To connect a DVI device, you will need:
• one HDMI-to-DVI adapter cable (HDMI type A connector)
per DVI device
- Forproper operation, the length of an HDMI-to-DVI
adapter cable should not exceed 9.8 ft (3m), The
recommended length is 6,6 ft (2m),
• one pair of standard analog audio cables per DV[ device
- An HDMI-to-DVI adapter cable transfers video on/y,
Separate analog audio cables are required (see
illustration).
Note: To ensure that the HDMI or DVI device is reset properly,
it is recommended that you follow these procedures:
When turning on your electronic components, turn on the
TV first, and then the HDM/ or DW device,
When turning off your electronic components, turn off the
HDM! or DVl device first, and then the TV
[1] EIA/CEA-861-D compliance covers the transmission of
uncompressed digital video with high-bandwidth digital
content protection, which is being standardized for reception
of highdefinition video signals. Because this is an evolving
technology, it is possible that some devices may not operate
properly with the T>
HDMI, the HDMI logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.
17