Table of Contents
Advertisement
of the delay start. The display shows the
indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pauza
pause the appliance. The related
indicator flashes.
2. Touch the Odložený start button
repeatedly until the display shows
the indicator
3. Touch the Start/Pauza
start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pauza
pause the appliance. The related
indicator flashes.
2. Touch the Odložený start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pauza
start the new countdown.
11.8 The SensiCare System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pauza
maximum declared load indicator goes off,
the SensiCare System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
Time Manager is available, during this
phase the Time Manager bars
placed below the time digits play a simple
animation. The drum rotates shortly.
button to
goes off.
button again to
button to
button again to
button, the
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
At the end of the load detection, in case of
drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauza
and
programme again. The SensiCare phase can
be repeated up to three times (see point 1).
Important! If the laundry amount will not be
reduced, the washing programme starts
anyway, despite the overload. In this case, it
will be not possible to guarantee the best
washing results.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The SensiCare detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced by means of the Time
Manager button.
The SensiCare System is not available
with all programmes such as :Vlna,
Rychlý 14 min,Máchání and programmes
with short cycles.
11.9 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the button Start/Pauza
The related indicator flashes.
is
button to start the
.
ENGLISH
25
Advertisement
Table of Contents
