Table of Contents
Advertisement
Set Supervisor / User Password
When you select this function, the following message will appear at the center of the screen to assist
you in creating a password.
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP / PCI CONFIGURATION
LOAD FAIL-SAFE DEFAULTS
LOAD OPTIMIZED DEFAULTS
ESC: Quit
F6: Load Fail-Safe Defaults
Type the password, up to six characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password
is disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords: a SUPERVISOR PASS
WORD and a USER PASSWORD. When disabled, anyone may access all BIOS Setup program
function. When enabled, the Supervisor password is required for entering the BIOS Setup program and
having full configuration fields, the User password is required to access only basic items.
If you select "Always" at "Password Check" in BIOS Features Setup Menu, you will be
prompted for the password every time the system is rebooted or any time you try to enter Setup
Menu.
If you select "Setup" at "Password Check" in BIOS Features Setup Menu, you will be prompted
only when you try to enter Setup.
AMIBIOS SIMPLE SETUP UTILITY - VERSION 1.24e
(C) 1999 American Megatrends, Inc. All Rights Reserved
Enter new supervisor password:
: Select Item
F7: Load Optimized Defaults
Change / Set / Disable Password
Figure 11: Password Setting
INTEGRATED PERIPHERALS
HARDWARE MONITOR & MISC SETUP
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
(Shift)F2 : Change Color
F8:Flash Utility
4 7
BIOS Setup
F5: Old Values
F10:Save & Exit
Advertisement
Table of Contents
