Table of Contents
Advertisement
Available languages
Available languages
EN
GENERAL SAFETY INSTRUCTIONS
1. Read the instructions and warning in this manual carefully, they
contain important information regarding safe installation, use
and maintenance.
This manual is an integral part of the product. Hand it on to the
next user/owner in case of change of property.
2. The manufacturer shall not liable for any injury to people, animals or
damage to property caused by improper, incorrect or unreasonable
use or failure to follow the instructions reported in this publication.
3. Installation and maintenance must be performed by professionally
qualified personnel as specified in the relative paragraphs. Only use
original spare parts. Failure to observe the above instructions can
compromise the safety of the appliance and relieves the manufac-
turer of any liability for the consequences.
4. DO NOT leave the packaging materials (staples, plastic bags, ex-
panded polystyrene, etc.) within the reach of children - they can
cause serious injury.
5. The appliance may not be used by persons under 8 years of age,
with reduced physical, sensory or mental capacity, or lacking the
requisite experience and familiarity, unless under supervision or fol-
lowing instruction in the safe use of the appliance and the hazards
attendant on such use. DO NOT permit children to play with the ap-
pliance. User cleaning and maintenance may not be done by unsu-
pervised children.
6. DO NOT touch the appliance when barefoot or if any part of your
body is wet.
7. Before using the device and after routine or extraordinary mainte-
nance, we recommend filling the appliance's tank with water and
draining it completely to remove any residual impurities.
8. If the appliance is equipped with a power cord, the latter may only be
replaced by an authorised service centre or professional technician.
9. It is mandatory to screw o the water inlet pipe of the unit a safety
valve in accordance with national regulations. In countries which
have enacted EN 1487, the safety group must be calibrated to a
maximum pressure of 1487 MPa (0,7 bar) and include at least a cock,
check valve and control, safety valve and hydraulic load cutout.
10. Do not tamper with the overpressure safety device (valve or safety
group), if supplied together with the appliance; trip it from time to
time to ensure that it is not jammed and to remove any scale depos-
its.
12
Advertisement
Table of Contents
