Sony VPL-SW620 Operating Instructions Manual page 52

Dual-user (Dual pen)
Main Pen toolbar
• The main pen toolbar is
displayed when the PC Free
Interactive function is
activated.
• Usable tools are different
between desktop mode and
whiteboard mode. The icons of
the unavailable tools are not
displayed.
Note
This is for the main pen only.
Sub Pen toolbar
• The sub pen toolbar is
displayed when the PC Free
Interactive function is
activated.
Note
This is for the sub pen only.
52
Using the PC Free Interactive Function (VPL-SW635C only)
Calibration Auto/Manual
Calibration aligns the points where the pen
(Main and Sub) is pointing and where the
projector displays the cursor on the screen.
" Calibration (Auto)
perform the calibration automatically.
If you select "Calibration (Manual (Main))
" or "Calibration (Manual (Sub))
can perform the calibration manually.
If you display the menu or the warning/
caution messages etc., are displayed during
the calibration, calibration will stop. In
addition, if you stop operating the
calibration for more than 20 seconds, the
manual calibration will also stop.
If the calibration fails,
on the calibration icon. In this case, perform
manual adjustment as needed.
Notes
Observe the precautions noted below during
the "Calibration (Auto)".
• Avoid placing obstacles between the
interactive detector and the screen.
• Do not move the projector and the screen.
If "Calibration (Auto)" does not calibrate
properly, try the following methods.
• Shield the screen from strong, direct outside
light.
• Reduce the ambient light while "Calibration
(Auto)" is performed.
• If "Calibration (Auto)" does not work
properly even though the ambient light is
reduced a little, select "Calibration (Manual
(Main))" or "Calibration (Manual (Sub))" to
make adjustments manually.
• If you use a screen which is not white,
"Calibration(Auto)" may be inaccurate.
Pen tracking speed adjustment
Tracking speed of the Interactive Pen Device
can be adjusted. If you are concerned about
shakes in drawn lines, set it toward "Slow".
However, setting toward "Slow" results in a
slow response when you draw fast.
SpeedSetting
Slow w
1 1 2 2 3 3 4 4 5 5
" allows you to
", you
will be displayed
Fast Fast
6 6 7 7 8 8 9 9 10 10