Sony VPL-SW620 Operating Instructions Manual page 30

Items
Direct Power On
Notes
*1: This may not be optimum depending on the input signal. In this case set manually according
to the connected equipment.
*2: When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
*3: This varies depending on the "Lamp Mode" setting.
*4: As the lamp is dimmed gradually, you may not notice any change in brightness. You might only
notice that the lamp has dimmed when its brightness is restored after there is a change in input
signal.
*5: This mode does not work for about three minutes after the lamp lights. A change in signal may
not be detected depending on the input image. The lamp may become brighter at intervals
during lamp dimming. However, this is not a malfunction. If With No Input is set, it takes
priority.
*6: Select "Off" to avoid entering standby mode when there is no input signal.
*7: Does not function when "Type A USB", "Type B USB" or "Network" is selected as the input.
In this case, it becomes equivalent to "Standard."
*8: Reflecting changes in WLAN settings may take a few moments.
*9: To set the IP address manually, select "Manual", press "Apply", then enter the IP address.
*10: When you send images or files from a tablet PC/smartphone and display them (page 61), set
"WLAN Network" to "Access Pt. (Auto)" or "Access Pt. (Manual)," to use USB wireless LAN
module IFU-WLM3 (not supplied) as a wireless access point.
*11: The factory default settings for "Access Pt. (Manual)" are as follows.
SSID: VPL + MAC address for LAN
Security Method: WEP(64bit)
Password: sony1
To change the settings for "Access Pt. (Manual)", use a Web browser.
For details, see "Setting the WLAN Network of the projector" (page 38).
If "Access Pt. (Manual)" is set, when you use Presentation Function via Network (page 58),
select "Manual Connect" to connect to the network.
*12: For changing the settings for "Client," use the Web browser for change. For details, see
"Setting the WLAN Network of the projector" (page 38).
*13: Constant Brightness mode will be enabled for about 2,000 hours after it is activated at early
usage. After this period, it will be disabled automatically. Activated time and brightness may
vary depending on the usage conditions.
*14: If the projector cannot connect wirelessly, click [Apply] once again to make sure the
connection is established. For details, see "Setting the WLAN Network of the projector"
(page 38).
*15: For VPL-SW635C, this does not function while the PC Free Interactive function is activated.
In this case, "Lamp Mode" becomes equivalent to "Standard" (page 33).
*16: For VPL-SW635C, this does not function when the PC Free Interactive function is activated.
In this case, "With No Input" will be "Off " (page 33).
*17: For VPL-SW635C, this does not function when the PC Free Interactive function is activated.
In this case, "With Static Signal" will be "Off " (page 33).
30
The Connection/Power Menu
Item descriptions
On/Off: When set to "On," you can turn the power on without going to
Standby mode when the AC power cord is connected to a wall outlet.
With the projector turned off, you can also unplug the AC power cord
without going to Standby mode, regardless of the Direct Power On
setting.