Table of Contents
Advertisement
•
Make sure that the cutting deck is level. Refer to
To adjust the parallelism of the cutting deck on
page 23 .
•
If the grass is high, start with a high cutting
height and decrease it gradually.
•
Move the product forward at low speed if the
grass is high and thick.
•
Use full throttle when you cut the grass.
•
Cut the grass in an irregular pattern.
•
Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the
cutting deck.
•
When you cut large areas, move the product
to the right during 1 or 2 turns around
the work area. This procedure will keep the
grass discharge away from shrubs, fences and
driveways. After approximately 2 turns around
the work area, cut in the opposite direction.
•
To get the best cutting result, cut the grass
frequently.
Introduction
WARNING:
the safety chapter before you do
maintenance on the product.
16
Maintenance
Read and understand
To put the product in freewheel
mode
If it is necessary to move or tow the product without
aid from the engine, you must put the product in
freewheel mode.
WARNING:
in freewheel mode on a slope.
•
Push in the freewheel control lever (A) to put the
product in drive mode.
A
•
Pull out the freewheel control lever to put the
product in freewheel mode.
Do not put the product
2285 - 001 - 17.10.2023
Advertisement
Table of Contents
