Table of Contents
Advertisement
Chapter 2
Switching on
Follow the instructions on this page on how to switch on your TV set and the remote
control before going on to following pages describing how to use the channel set-up
procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specified.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
-
Do not expose batteries to excessive heat such as sunshine, fire or the like,
throw them in a fire, recharge them or try to open them, as this could cause
them to leak or explode.
- Remove the batteries from the remote control if you are not using it for a long
period of time.
2. Connect the power cable FIRST to the television, THEN to a mains socket.
Plug the cable on the AC adapter into the TV. Then plug the mains cable into
the socket.
If the plug is detached from the cable, do not, under any
circumstances, connect it to a mains socket, as there is a risk of electric shock.
Note: 1)The figures are for representation only. The location of the power socket
at the back of the television might differ depending on the model.
2)
If the mains power is not cut off, this set and the AC
adapter will always consume some electric power.
3. Connect an outside aerial to the ANTENNA IN socket at the back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting
an external aerial or other equipment fitted.
4. When powered on, the TV will be turned on directly.
If the power indicator lights up, the TV set is in standby mode. Press the
button on the remote control or at the bottom of the TV set to turn on the TV.
Switching off
To put the TV set into standby mode, press the
or on the TV, the TV set remains powered up, but with low energy consumption.
To switch off the TV set, unplug the mains socket from the mains outlet.
7
General Operation
button on the remote control
Advertisement
Table of Contents
