Pioneer XR-P270C Operating Instructions Manual page 8

e The illustration shows model XR-P270C.
@ La ilustracién muestra el modelo XR-P270C.
@A ilustragaéo mostra o modelo XR-P270C.
1
8
<ARE7108>
En
CONNECTIONS
Before making or changing the connections,
switch off the power switch and disconnect
the power cord from the AC outlet.
1. Connect the AM loop antenna and FM antenna to the
ANTENNA terminals.
2. Connect the speaker cords to the FRONT SPEAKERS
terminals.
Connect the white with gray line cords to the "+" (red)
terminals and the white cords to the "—" (black) terminals.
@ Twist the wire strands.
Push away the tab and insert the cord into the terminal.
Pull back the tab. Be sure to tighten the cords firmly.
ore)
NOTE:
Do not allow the conductors of the cords to project out of the
terminals or to come into contact with other conductors. A
breakdown or failure may occur when conductors touch.
3. Connect the speaker cords to the speaker's rear terminals as
shown in the illustration. (XR-P170C only)
@ Open the cover.
@ Insert the cord.
@) Close the cover.
NOTE:
Connecting to the speaker is not necessary for speakers equipped
with direct input cords. Connect the speaker cords directly to the
SPEAKER terminals of the RECEIVER.
Speaker impedance
Connect speaker systems with a nominal impedance ranging
from 4Q to 16 Q.
Precautions for the S-P270 and S-P170
eThese speaker systems are not magnetically shielded, and
may cause color noise or distortion when placed very near a
television set. If this occurs, place the speakers farther away
from the television set.
Do not connect to any amplifier other than the one supplied
with these speaker systems. Connection to any other amplifier
may result in a malfunction or a fire.
4. When using a VCR or DAT, connect the audio cable to the
AUX input jacks.
5. Finally, plug the power cord into the AC wall outlet.
NOTE:
insert the plugs securely into the jacks. Improper connection
can lead to sound distortion or malfunction,