Turning On The Power; Turning Power On Without Using The Power Switch; Tuning Into Stations; Beat Cut Function - Pioneer XR-P770F Operating Instructions Manual

TURNING ON THE POWER
Operations indicated by the [ G ] mark are performed with the
remote control unit.
e@Read "CONNECTIONS" again and ensure that speakers,
antenna, etc., are connected properly.
Press the POWER switch.
To switch the power OFF: .
Press the POWER switch again and the STANDBY indicator lights.
You cannot see the clock display in this unit.
Press the DISPLAY/RDS CLOCK ADJ button to see the clock
display.
Turning power ON without using the POWER switch
Performing any of the following operations while the system
power is off (STANDBY) turns the power ON.
If a CD has been loaded, it
starts to play.
The tuner (radio) input is
selected.
If a cassette tape has been
loaded, it starts to play.
Ifthe connected component
is operating, it startsto play.
Play starts if there is a CD in
the selected 5-disc access.
The function which has
been selected beforethe last
time the power was
switched off is selected and
the corresponding opera-
tion starts.
@When power is OFF (Standby), press the SLOT EJECT button,
and power switches ON, letting you remove a disc. Also, when
power is OFF (Standby), if you load a CD in the Plus 1 Disc Slot,
Power automatically switches ON, and play starts.
TUNING INTO STATIONS
@ Be sure to connect the antennas.
eDo not place the AM antenna on a metallic case including the
receiver cabinet or near a CD player, LD player, DAT recorder,
personal computer or TV set. Any of these installations will
cause noise in reception.
|
i
=, |
:
f
1. Press the tuner (FM/AM) function button.
Select the FM or AM broadcasting band.
Each time you press this button, FM and AMchangesalternately.
eee ec ees
2. Tunein the desired station by pressing the C-) or (= button.
e@ Manual tuning
Tap the C=) or (=) button in quick repetitions.
e Auto tuning
Press the C=) or C=) button for a second or two and remove your
finger from it when the frequency starts to change.
—The frequency changes automatically. When astationis received,
the frequency stops changing and "TUNED"
appears on the
display.
e High-speed manual tuning
Press and hold the C=) or (3 button.
MONO button (Remote control unit only)
Beat cut function
@To cancel the BEAT CUT function, repeat steps 1 and 2.
AM ]954_
BEAT CUT indicator lights.
11
<ARB7110>