Supplying Power (Battery Charge/Use/Refreslvcare, Acadaptor, Carbattery Cord) - Panasonic Palmcorder PalmSight PV-L501 Operating Instructions Manual

m iii I
Charge Battery Pack fully before use.
POWER 2_/_
(Top View)
Supplying Power
Plug in
POWER Lamp lights.
2 Insert Ba___.@._.
e Align left side of Battery with le. edge of
AC Adaptor.
Q Press Battery down and slide in direction
of arrow.
The CHARGE Lamp flashes, then stays lit
when charging is complete.
Remove BaHerv.
Slide Batteryto the left and lift off.
Note:
• Charging takesaboutI hour (PV-L501)or 1and 1/2
• hours PV-L551/PV-L601/PV-L651,
Wh e the DC PowerCabe supped) s connected
to the AC Adaptor, t he Batterycannotbe charged.
• After charging5 times,use BatteryRefreshfeature
as explainedbelow.
• Batterylifegraduallydecreasesafter repeateduse
and recharging.If operationtime becomesvery
shod evenaftera sufficientcharge,discardBattery
propedy(page 10).
A fullycharged Batteryprovidesa maximum of about 1 hour 10 minutes (PV-LS01)or 2 hours
(PV-L551/PV-L601/PV-L651) of continuoususe (LCDmonitoroff)or about 55 minutes (PV-L501)or
1.5 hours (PV-L551/PV-L601/PV-L651 ) (LCDmonitor o n). Actualtime may vary dueto operating
conditions.Usingthe Built-inLightdecreasesoperatingtime(PV-L551/PV-L601tPV-L651 only).
B
A Attach Battery=.
O Insert top of Battery into top of mounting
surface.
(_ Press and snap into place.
B RemoveBattery.
Slide BATTERYRELEASEand remove
Ba_ely.
This feature completelydischarges
Batterybefore recharging begins.
Use after every 5 charges for optimum
Battery performance.
REFRESH
REFRESH
To use battery refresh, insert Battery on AC
Adaptor (see steps 1~2 above), then press
The REFRESH Lamp lights,then goes out
when discharge is complete, Batterycharging
will then stad automatically.
If _ is pressed by mistake,
remove BaRely from AC Adaptorandreinsert it
for normal charging.
Note:
• Charging takesabout 5 hours (PV-L501)or7 and
1/2 hours(PV-L551/PV-L601/PV-L651) when
BatteryRefresh is used.
• Batterywillnotoperateinextremely high
temperatures.
9