Table of Contents
Advertisement
ADJUSTMENT
ADJUSTING THE TV
Your TV receiver must be adjusted to receive the signal
from your recorder. If you connect a color monitor, It
does not need adjusting.
POWER
=
ORT
If you do not have a recorded video cassette tape
if you have a recorded video cassette tape
@ Set RF UNIT located in the tuning compartment to 3 CH or 4 CH
whichever channel is not active in your area.
@ Press POWER. The lamp lights.
@ Insert the cassette with the
round window to the left.
@ Press
& PLAY.
© Press TV/VTR
to display the VTR
Indicator in the window.
@ Check that INPUT SELECT is set to
TUNER,
then
select
an
active
channel in your area with the +/-
button on the recorder.
.@ Turn on the TV.
@ Set the TV receiver to either VHF channel 3 or 4 to agree with the
RF UNIT setting.
The TV program selected on the recorder or the tape program will
be displayed on the TV screen. If a picture does not appear on the
TV screen or if the display ts not clear, fine-tune the channel on the
TV.
e@ For details about TV channel adjustment, see the instruction
manual of the TV receiver.
Check!
Check that the display on the screen
changes when you stop the tape by
pressing m STOP on the recorder. (To
Check!
Check that the program displayed on
the screen changes when a different
channet is selected on the recorder. If
the program does not change, repeat
the preceding steps.
eject the cassette, press & EJECT.)
lf the
program
does
not
change,
repeat the preceding steps.
Now your TV receiver is tuned to the recorder. Whenever you
use the video recorder, you should set the TV to the channel
which you have chosen above.
Advertisement
Table of Contents
