Ferroli DIVATOP D HF Instructions For Use, Installation & Maintenance page 52

Installer menu [SERVICE]
After selecting the installer menu [Service], press the button
buttons and
Confirm with the button
• [TSP] - Menu for modifying transparent parame-
ters
• [Test] - Activation of boiler Test mode.
• [OTC] - Setting of heating curves for adjustment
with external probe.
• [Zone] - Settings of heating curves of additional
zones.
• [Auto Setup] - This menu is used to activate cali-
bration. Visible only with parameter b12 set to 1.
Boiler information menu [Diagnostic]
This menu provides the information, in real time, of the various sensors present in the boiler.
To access it, press the button
52
DHW to set the cell value, and the buttons
PASSWORD
0 0 0 0
fig. 15- Password entry
to access the installer menu[SERVICE] screen where the following menus are available:
from the main screen, select the item [Diagnostic] and confirm with the button
CH 1 temp
CH 2 temp
DHW temp
Ext temp
Power
DHW flow
Water Pressure
Flame
cod. 3540000180 - Rev. 00 - 05/2023
. To continue, enter the password "1234". Use the
and heating to shift position (fig. 15).
PASSWORD
1 2 0 0
DIAGNOSTIC
27
°C
26
°C
25
°C
--
°C
--%
0,0
l/min
Ok
--
fig. 17
DIVATOP D HF
SERVICE
TSP
Test
OTC
Zone
Setup
fig. 16
.
EN