Installing The Control Rods - Toro 30434 Operator's Manual

Note: Tighten left side of shift lever plate until it is
completely tight and then unscrew the locknut one full
turn. This will allow the spring to work.
7
3
4
5
Figure 4
1. Bolt, 5/8 x 7/8 inch
2. Lock washer, 5/16 inch
3. Washer, 5/16 inch
4. Spring
6
3
2
1
m–6583
5. Locknut
6. Hose clamp
7. Fuel tank connection
15
Parts needed for this step:
2 E–clips

Installing the Control Rods

1. For a starting point, make sure the rod fittings are
threaded approximately 2–1/2 inches (63 mm) onto the
control rods (Fig. 5).
2. Install the rod fittings into the and secure them with
E–rings (Fig. 5).
4
2
3
Figure 5
1. Control rod
2. Rod fitting
1
m–6601
3. 2–1/2 inch (63.5 mm) from
bottom
4. E–ring