Adjusting The Clock .E7 - Fisher PH-DTA100 Operating Instructions Manual

ADJUSTING THE CLOCK
NOTE:
When the unit is first connected to the AC
power line, the clock display blinks on the
display.
Example: To set the "PM 6:30".
Use the main unit or the remote control for
this operation.
1. Press [CLOCK] for at least 2 seconds. The
clock display blinks.
CLOCK
3. Press [CLOCK], The clock starts.
CLOCK
on nc'jo
I II
ULI; JU
• To display the clock during operation, press
[CLOCK] briefly. After a few seconds, the
original display returns.
• If a power failure occurs, reset time again.
\ I / \ I /\ I /
0 n I j- n n
III! ILIJIJ
2. Press [VOLUME] + or - to set "PM 6:30".
\i/\i/ \i/\i/
on ncjn
I II IJU JU