For Safe And Efficient Operation.e3 - Fisher PH-DTA100 Operating Instructions Manual

FOR SAFE AND EFFICIENT OPERATION
• Use this only with the supplied AC adaptor. Other AC adaptors could damage the unit. Do not
touch the AC adaptor with wet hands. Doing so is dangerous, as this could result in an electrical
shock.
• If water should enter the unit, electrical shock or a malfunction may result. Use in an area where
there is low humidity and little dust.
• Do not disassemble or alter the unit in any way.
• Do not use the unit in areas where extremes in temperature occur (below 40°F or exceeding
95°F), or where it may be exposed to direct sunlight.
• Because of the CD player's extremely low noise and wide dynamic range, there is a tendency
to turn the volume on the amplifier higher than necessary. Doing so may produce an excessively
high output from the amplifier which can cause damage to your speakers. Please be careful in
this regard.
• Sudden changes in the surrounding temperature can cause dew to form on the optical pickup lens
inside the unit. Under this condition the unit may be unable to operate properly. If this should
occur, remove the disc and allow the player to adjust to the surrounding temperature.
• The speaker uses a strong magnet. Keep it away from TV, cards with magnetically coded
strips, and etc.
WHAT TO DO IF
If the operation of the unit or display is not normal, even though the appropriate buttons have
been pressed.
1. Disconnect the AC adaptor.
2. Wait for at least 30 seconds.
3. Connect the AC adaptor again.
4. Press [cb/ON] to turn on the power.
5. Press the desired function button.
NOTE:
If the unit does not operate correctly, please contact your nearest Fisher Authorized Service Center.
-E3-