Safety Certification.e2 - Fisher PH-DTA100 Operating Instructions Manual

WARNING:
UNAUTHORIZED RECORDING OF COPYRIGHT MATERIAL MAY VIOLATE
APPLICABLE COPYRIGHT LAWS. THE MANUFACTURER ASSUMES NO
RESPONSIBILITY FOR UNAUTHORIZED DUPLICATION, USE OR OTHER
ACTS WHICH INFRINGE UPON THE RIGHTS OF COPYRIGHT OWNERS.
SAFETY CERTIFICATION
This unit is made and tested to meet exacting safety standards. It meets FCC require¬
ments and complies with safety performance standards of the U.S. Department of Health
and Human Servioes.
CAUTION - USE OF CONTROLS OR
PROCEDURES OTHER THAN THOSE
ARDOUS RADIATION EXPOSURE.
ADJUSTMENTS OR PERFORMANCE OF
SPECIFIED HEREIN MAY RESULT IN HAZ-
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED
PROPERLY QUALIFIED SERVICE PERSONNEL.
BY ANYONE EXCEPT
FCC INFORMATION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by Fisher may void the user's authority to operate
this equipment.
^
Kciaic
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device
anpinTh
to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and. if not installed and used in accordance with the instructions may
cause harmful interference to radio communications. However, there is no guarantee that interfer¬
ence wil not occur in a particular installation.
If
this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on the user
IS
encouraged to try to correct the interference
by
one or more of the following measures;
• Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. is
• Consult the dealer or an experienced radio/TV technician for help.
-E2-