General Installation Information; Purpose Of Scope; Safety; Standards Booklet - Generac Power Systems NP-30G Series Owner's Manual And Installation Instructions

GENERAL INSTALLATION INFORMATION
PURPOSE AND SCOPE OF MANUAL
These Installation Instructions have been prepared
especially for the purpose of familiarizing installers
and owners of the applicable equipment with the pro-
duct's installation requirements. Give serious consid-
eration to all information and instructions in the
Manual, both for safety and for continued reliable
operation of the equipment.
Because of the different recreational vehicle models
and the variations between the models, it would be
extremely difficult, if not impractical, to provide
detailed instructions on every installation possibility.
For that reason, instructions and illustrations in this
manual are general in nature. Illustrations are not
intended to serve as detailed installation blueprints.
The installation should comply strictly with all applica-
ble codes, standards and regulations pertaining to the
installation and use of this product. If any portion of
this manual appears to be in conflict with such codes,
standards or regulations, the applicable codes, stan-
dards or regulations must take precedence over the
manual.
SAFETY
Before handling, installing, operating or servicing this
equipment, be sure to read carefully the "Notice to
Installer'' and "Safety Rules" at front of this manual.
Comply with all SAFETY RULES to prevent death,
personal injury or damage to equipment and/or prop-
erty. Stress safety to all installers, operators and ser-
vice technicians who work on this equipment.
STANDARDS BOOKLETS
Installation, use and servicing of this equipment
should comply strictly with published standards, as
well as the manufacturer's recommendations. The fol-
lowing standards booklets (latest revision) are avail-
able from the sources indicated:
1. NFPA Standard 501 C, "Standard for Recreational
Vehicles", available from the National Fire Protection
Association, Batterymarch Park, Quincy, MA 02269.
2. NFPA 70, "NFPA Handbook of the National Electric
Code", obtained from same address as Item 1.
3. ANSI C1-1975 and ANSI 119.2-1975, available from the
American National Standards Institute, 1430 Broadway,
New York, NY 10018.
4. ANSI A 119.2/NFPA 501 C, available from the
Recreational Vehicle Association, 1896 Preston White
Drive, Reston, VA 22090.
5. California Administrative Code, Title 25, available from
the State of California, Documents Section, P.O. Box
1015, North Highlands, CA 95660.
6. CSA Electrical Bulletin 946, available from the Canadian
Standards Association, Housing and Constructions
Materials Section, 178 Rexdale Boulevard, Rexdale,
Ontario, Canada, M9W 1 R3.
EQUIPMENT DESCRIPTION
Instructions and information in this section pertain to
Generac air-cooled generators - more specifically,
the installation of NP30 recreational vehicle genera-
tors. These generators are designed specifically for
installing in recreational vehicles.
ENGINE GENERATOR
OPERATING SPEED
The generators are driven by single-cylinder engines.
The engines drive revolving fields (rotors), high fre-
quency, permanent magnet alternators. The genera-
tors supply 120 volts AC at 60 Hertz. The generators
revolving fields are driven at a variable speed
depending on the instantaneous demand for power.
Computers monitor that demand and adjust the
engine speed to provide adequate power to the con-
nected loads.
GENERATOR AC CONNECTION
SYSTEM
The generators are equipped with single voltage AC
connection systems. The following facts pertain to
such a connection system:
• On the units, the 120 volts, connections system is pro-
tected by a circuit breaker.
• The AC connection system on all air-cooled generators
use a GROUNDED neutral.
• A separate green ground wire is connected to the recre-
ational vehicle's junction box.
-14-