Table of Contents
Advertisement
iK81 / iK42
USER GUIDE
Utility Pages
Screen Contrast
The Screen page in the "UTILITY" section adjusts the contrast (and optimal viewing angle) of the screen from 0-100% in 1%
increments.
Stereo Linking
Stereo linking is available between DSP Drive Modules A & B and between C & D. Changing a parameter in either of the stereo
linked Drive Modules will change the other linked Drive Module. Stereo linking is controlled by the STEREO page in the "UTILITY"
menu.
Note: Stereo linking will only work when the linked Drive Modules are of equal size. Note: Stereo Linking state is not stored in
Presets (but is stored in Snapshots)
Current Ethernet IP Address
This may be viewed in the "IP Curr" page of the "UTILITY" menu. This value cannot be edited.
IP Mode
The Ethernet IP address may be automatic "Auto" or may be a fixed static value "Static" as determined by the "IP Mode" page
of the "UTILITY" menu.
WARNING – Do NOT use Static mode unless your IT system specifically requires it. Auto mode should always be used where
possible since in this mode, the Device can always be 'discovered' by the Vu-Net application. When in Static mode, the IP
Address will flash on the Home screen.
See also Ethernet Configurations.
IP Static
This allows the Static Ethernet IP address to be adjusted by the rotary encoders on the IP Static page of the "UTILITY" menu. This
page will only be visible when in Static mode.
Store Snapshot
This page of the "UTILITY" menu allows a Snapshot of the device to be stored.
See also Snapshots.
Recall Snapshot
This page of the "UTILITY" menu allows a Snapshot to be recalled.
See also Snapshots and Aux Port.
Bandwidth Units
This page of the "UTILITY" menu allows the Bandwidth of Parametric Equalisers to be viewed and adjusted in either Octaves or
'Q'.
Aux Style
This page of the "UTILITY" menu allows the action of the Aux port to be viewed and adjusted.
See also Aux Port.
ECO
This page of the "UTILITY" menu allows the device to save power by going into a low power mode when it is not being used.
Standby is a fast mode which saves some energy, but will wake-up very quickly if an audio input is detected. The associated
Standby Time parameter allows the amplifier to automatically go into power-save if no audio signal has been detected for a
period of time. This function can be defeated by setting the latter control to Manual. Linea would strongly advise leaving it set
to automatic however as there is no negative consequence to doing this since 'wake-up' on detecting the presence of an audio
input signal is instantaneous.
iK81 / iK42 User Guide V2.3
32
Advertisement
Table of Contents
