Loading Xe300 Passive Presets - Martin Audio Ikon IK81 User Manual

Table of Contents

iK81 / iK42

You will notice that the screen is now showing the preset for input B. Again using the Adjust control select the XE500

preset and press "Enter";-

Press "Enter" and the preset loading is complete, press "Utility" to escape back to the default screen;-

This shows that DSP A and B are both loaded with the XE500 preset. Input 1 is routed to output 1&2, input 2 is routed

to outputs 3&4, inputs 3 and 4 are not used therefore not routed anywhere. The amplifier is ready for use.

Loading XE300 Passive Presets

Loading presets for passive monitors is exactly the same procedure other than it being necessary to define the preset for all four

Inputs.

Connect the amplifier. The iK42 requires mains connected to its 32Amp PowerCon inlet, an input feed, either balanced



analogue to the input XLRs, AES3 to the dedicated AES XLR, or Dante to the Dante RJ45 port. XE300 in passive mode

can be connected directly to output Speakons 1, 2, 3 and 4. See the chapters on mains, input and output connections

for more details.

Power up the amplifier, once it has completed its power-up cycle press "Input" and press the down arrow once to show



the Preset recall for Channel A-

Use the Adjust control to scroll round to the required XE300 Preset;-



iK81 / iK42 User Guide V2.3

USER GUIDE

Table of Contents

Ikon ik42