Switch The Steam Generator On; Operating The Control Panel; Eco Intelligence; Use - Rowenta SILENCE STEAM User Manual

Switch the steam generator on

The first time the appliance is used, there may be some fumes and smell but this is not harmful. They will not
affect use and will disappear rapidly.
• Put the steam generator on a flat, stable, horizontal surface that is heatproof.
• Always ensure that the base unit is positioned close enough to the ironing surface to avoid straining and wear of the
steam cord.
• Completely unwind the power cord and take the steam cord out of its storage space.
• Plug your steam generator into an earthed socket.
• Press the «ON-OFF» button.
• The «ON-OFF» button light remains flashing while the appliance is warming up. When the light stops flashing (after
approximately 2 minutes) the steam generator is ready.

Operating the control panel

• The green light of the «ON-OFF» button is flashing : the boiler is heating up. When the light stops flashing, the steam
generator is ready.
• Your steam generator comes with an automatic shutoff system after approximately 8 minutes without use. The «ON-
OFF» button light is flashing: the steam generator is on standby. Press the «ON-OFF» button or the steam shot button
to start ironing again. See paragraph «AUTO-OFF» System.
• The red «Water tank empty» button light is flashing: the water tank is empty, refilling is required, See paragraph
''refilling the water tank during use''.
• The orange "Calc-Away" light is flashing : the collector needs to be rinsed, see paragraph «Maintenance and cleaning».
Regulation
• Place the iron's temperature control to the type of fabric to be ironed and set the steam output. See the table here
below.
T S
YPE OF FABRIC
S
YNTHETICS
(P , A , A , P )
OLYESTER CETATE CRYLIC OLYAMIDE
S / W **
ILK OOL
C / L
OTTON INEN
• The iron temperature control light turnson.
Important: whenever you start using your iron and whenever you reduce the temperature during use, the iron is ready
for use when its temperature control light goes out and when the green light located on the control panel
comes on and remains on.
• During use, when you increase the temperature of the iron, you can start ironing immediately, but make sure you only
increase your steam output once the iron's thermostat light has gone out.
Warning, fabrics with the symbol are not suitable for ironing.
ECO Mode
(depending on model)
• Your steam generator has an ECO mode function which uses less power whilst still guaranteeing a sufficient steam
output for you to iron your garments properly. In order to use this function, once the thermostat of your iron has been
correctly set (see table above), position the steam output setting on the ECO segment.
The ECO mode can be used with all types of fabrics. However, for very thick or creased fabrics, we recommend that you
use the maximum steam output or the Boost function in order to ensure optimum results.
l**If you are ironing woolen garments, press repeatedly on the steam shot button without placing the iron on the garment. This will avoid it
becoming shiny.
S
ETTING TEMPERATURE ETTING STEAM CONTROL
•
• •
• • •
18

Eco Intelligence

(depending on model)
• Your steam generator is fitted with an Eco Intelligence electronic control system that provides optimal control of the
iron's steam output and temperature according to the selected fabric: this reduces energy consumption and
guarantees optimum ironing for each type of fabric.
• Set the control button to the type of fabric to be ironed (see table below).
S
YNTHETICS
(P , A , A , P )
OLYESTER CETATE CRYLIC OLYAMIDE
S
ILK
W
OOL
C
OTTON
L
INEN

Use

Steam ironing
Recommendations: To prime the steam circuit, either before using the iron for the first time, or if you have not
used the steam function for a few minutes, press the steam control button several times in a row, holding the
iron away from your clothes. This will enable any cold water to be removed from the steam circuit.
• To obtain steam, press the steam control button under the iron handle. The steam will stop when you release the
button.
• After approximately one minute, and regularly while it is being used, your steam generator's electric pump injects
water into the boiler. It makes a noise but this is quite normal.
• If you are using starch, always spray it onto the reverse side of the fabric to be ironed.
"Boost" function *
)
• Your generator is equipped with a "Boost" function that allows you to increase steam output during use at particular
moments and for particularly difficult areas, for example if you are ironing very thick or very creased fabrics.
• To use this function, set the iron thermostat to the maximum position (•••) and then press on the Boost button located
on the control panel. A blue light turns on.
• To deactivate the Boost function, press the button again. The blue light will then turn off. This function may also
bedeactivated by turning the steam output control dial.
• The Boost function is deactivated automatically after 15 minutes. The blue light flashes to indicate that the Boost
function will turn off, then turns off.
The Boost function can only be used on the "Wool", "Cotton" and "Linen" positions. For other fabrics, there is
no need to use the Boost function as the combinations of "Synthetic" and "Silk" settings are sufficient.
Precision Shot
• Your appliance comes with a Precision Shot function : It allows you to make a concentrated steam injection when
ironing hard creases, details and difficult access areas.
• To use this function, press fully on the Precision Shot button located on top of your iron as many times as necessary.
Burst of steam *
(triple clic)
• Your appliance comes with a burst of steam: an automatic sequential steam for effortless use. To be used in particular
for thick fabrics.
•To obtain this function, press the steam control button under the handle three times in quick succession.
Attention! Use the Precision Shot and burst of steam carefully, as the steam comes out with exceptional force
and could cause burns.
Vertical steam ironing
Recommendations: for fabrics other than linen or cotton, hold the iron a few centimetres from the garment to avoid
burning the fabric.
For delicate fabrics such as synthetics or wool, it is not necessary to use the "Boost/vertical steam".
• Set the iron temperature control to the maximum position (•••) and press the Boost/vertical steam button.
*depending on model
19