Table of Contents
Advertisement
Figure 3-14 Bind the radio to and enable the wireless servic
Click the Bind link in the Wireless Service column, select the target radio, and click Bind.
Select the psk check box.
Click Enable.
5)
Enable 802.11n (2.4GHz) radio (By default, 802.11n (2.4GHz) radio is enabled. Therefore, this
step is optional.)
Select Radio > Radio from the navigation tree to enter the Radio page. Make sure that 802.11n
(2.4GHz) radio is enabled.
Configuration verification
The same PSK pre-shared key is configured on the client. The client can successfully associate with the
AP (as shown in
Figure 3-15 The client associates with the AP
Configuration guidelines
When satisfied with the configuration
Point restarts.
Local MAC Authentication Configuration Example
Network requirements
As shown in
Figure
Figure
3-15)and can access the WLAN network.
Save Configuration to File
3-16, configure the fat AP to perform MAC authentication on the client.
e
to ensure it is not lost when the Access
3-7
Advertisement
Table of Contents
