Weider FLEX XT2 Owner's Manual page 14

WEIDER HEALTH & FITNESS pace 13
STEP 12 ARM PRESS ASSEMBLY
ARI
21 5/16" FLAT WASHER
та ЗО OR LOCK NUT | C] Assemble ARM PRESS ARM (18) into MAIN FRAME (1). TO DO
24 5/16" X 3 1/4" HEX HEAD BOLT THIS, TURN HANDLE BAR AT AN ANGLE SO THAT THE HANDLE
70 1" ROUND PLASTIC INSERT CAP
BAR EXTENSION
AND WELDED SPACER
FIT INTO THE
72 PLASTIC BUMPER OPENING OF THE FRAME. ONCE INSIDE THE FRAME TUBE
CURT Vx Y . siz TWIST THE HANDLE BAR BACK INTO A STRAIGHT ALIGNMENT.
SEE DETAIL A! Bolt Handle Bar into position using 5/16" X 3 1/4"
HEX HEAD BOLT (24), 5/16" FLAT WASHERS (21), and 5/16"
NYLON LOCK NUT (22).
DETAIL A
L] Press 1" ROUND PLASTIC INSERT CAP (70) onto
ends of Handle Bar.
О Wipe liquid dish detergent over surface of Handle Ваг
епсв and press on 1" X 5" FOAM GRIPS (71).
ГО Assemble PLASTIC BUMPER (72) to bottom side of
Long Slot in MAIN FRAME (1) where it comes in
contact with ARM PRESS ARM (18). SEE DETAIL B!
(FOR BEST RESULTS GLUE THE PLASTIC
BUMPER.)
LJ Position ARM PRESS RESISTANCE SCALE DECAL
(50) on top side of ARM PRESS ARM (18).
DETAIL B