Graco 25M480 Instructions Manual page 6

Installation
5. Attach ground wire to ground terminal inside
junction box (S).
NOTE: The power cord attaches to a separate
ground screw than the ground screw that is already
attached.
F . 4: Attach Ground Wire
IG
6. Place fan wires and other power wires into open
area on either side of disconnect block (J) as space
permits. Reinstall junction box cover. See F
NOTICE
If wires get pinched when the screws are tightened,
damage will occur. Make sure all wires are routed
correctly before installation.
G
E
F . 5: Grounding Wire
IG
6
. 5.
IG
J
7. Replace junction box screws and washers removed
in step 2 and tighten cord grip to securely hold
power cord in junction box (S). See F
F . 6: Junction Box Screws and Strain Relief
IG
. 6.
IG
S
3A5173A