Related Manuals for Milwaukee M18 FR12
Summary of Contents for Milwaukee M18 FR12
- Page 1 OPERATOR'S MANUAL Cat. No. M18 FR12, RBA-1 M18 FUEL™ 1/2" ROUTER 1/2" ROUTER PLUNGE BASE WARNING To reduce the risk of injury, user must read and understand operator's manual.
-
Page 2: General Power Tool Safety Warnings
GENERAL POWER TOOL • Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left SAFETY WARNINGS attached to a rotating part of the power tool may Read all safety warnings, instruc- WARNING result in personal injury. -
Page 3: Specific Safety Rules For Routers
Maintain labels and nameplates. These carry • forces. The operator can control kickback forces, if important information. If unreadable or missing, proper precautions are taken. contact a MILWAUKEE service facility for a ® • Some woods contain preservatives that can be replacement. -
Page 4: Specifications
Handle batteries. Gripping surface SPECIFICATIONS Depth adjust button Cat. No..........M18 FR12 10. Locking lever Volts............18 V DC Battery Type ..........M18™ Charger Type..........M18™ No Load RPM ........ 12,000 - 25,000 13 mm (1/2"), 6.35 mm (1/4"), Collet Size .... - Page 5 Changing Collet Nuts ASSEMBLY The router can be fitted with either a 13 mm (1/2"), Recharge only with the charger WARNING 6.35 mm (1/4"), 6 mm, 8 mm or 12 mm collet nut for specified for the battery. For different applications. specific charging instructions,...
-
Page 6: Operation
Installing a Dust Shroud OPERATION To reduce the risk of injury, do WARNING To reduce the risk of injury, WARNING not use the dust shroud when always wear proper plunge cutting if the bit is larger than the port protection marked comply with... - Page 7 Adjusting the Depth of Cut Multiple Pass Cuts For cuts more than 3.2 mm (1/8") deep, multiple Pressing the depth adjust button WARNING passes are necessary. will cause the console to drop down, which may cause personal injury or 1. Remove the battery pack. damage to the tool or workpiece.
- Page 8 Slide Switch Operation Fixed Base with an Edge Guide To start the tool, grasp the handle(s) firmly, slide To obtain a straight cut, use the edge guide, or clamp a piece of scrap lumber to use as a guide. the switch upward and push forward to lock the tool into the ON position.
-
Page 9: Maintenance
Return the tool, battery pack, and except as provided in these instructions. charger to a MILWAUKEE service facility for repair. ® Contact a MILWAUKEE service facility for all ®... - Page 12 Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE ® prides itself in producing a premium quality product that is Nothing But Heavy Duty Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE ®...