Control Panel Procedure - Citizen 120D+ User Manual

SET UP
FF (Form Feed) and Auto Sheet load switch
When the printer is off-line, pressing the form feed switch
advances the paper to the top of the next page or can
advance a new sheet automatically for you.
The control panel switches also play a part in turning on
three of the 120D + 's very special features: the printer self¬
test, the maintenance self-test, and the hex dump feature.
The two self-tests are co.
^
later in this chapter; the hex
dump feature is described in u9.
NLQ
_ paper out
ONLINE LF
1=3 FONT 1/FONT 2
FF
AUTO SHEET LOAO
Cl RFADY 1 1 1
1 1
FONT 1/FONT 2
Figure 1-5.
The 120D+ printer
control panel.
CONTROL PANEL PROCEDURE
The control panel will allow the operator to access seven
different print styles, two character font styles and
ASF/forms length selection.
To enter the print style select mode with the printer ON
LINE, the operator will depress the FF button (hold it down)
and then depress the ON LINE button.
When the operator enters the print style mode the printer
will clear itself to the standard mode and the ready light
will start flashing.
To access each of the print styles shown as below, the
operator will depress the ON LINE button. For example, the
operator will depress the ON LINE button twice (2) to
access the ITALIC mode.
Each time the operator depresses the ON LINE button, the
"PAPER OUT" light will flash.
After accessing the desired font mode, the operator will
then depress the FF button and release it.
The operator will then depress the LF button, which will
take the 120D + out of the print style select mode.
Print style Select
Draft (Power on default) 0
Near Letter Quality (NLQ) 1
Italic 2
Emphasised
3
Reduced
4
Double height/width 5
Quadruple height/width 6
Only one (1) style will be accessable in another manner
than that stated above. This is the NLQ font. To access the
NLQ style without entering the print style select mode, the
operator will depress the LF button and hold it in. They will
then depress the ON LINE button and hold it in. Both
buttons may then be released. Upon their release the
120D + will enter the NLQ mode. To exit this mode, the
operator need only repeat the above procedure.
5