Advertisement
Specification
Power supply requirements:
From batteries:
Radio: 9 V DC supplied by six HP 2
(IEC R 20) batteries or equivalent, eg:
Varta 3020 or 4020
For LCD clock and memory: Two HP 7
(IEC R 6) batteries or equivalent, eg: Varta.
4006, Daimon 242, Philips 4506, Ucar 410
or Mallory MN 1500.
From external DC supply: 10-16 V DC
(via socket ®)
From mains: via built-in power supply
unit; adjustable to 220-240 V (GB: 240 V
AC) or 110-127 V + 10%; 50/60 Hz.
Mains switch in transformer secondary
circuit:
Fuses:
315 mA time-lag to IEC Ill
2A
time-lag to IEC IH
2A
time-lag to IEC ll
200 mA time-lag.to BV 0820-455.97
Thermal cut-out to drawing
No. 09623-332.04
600 mA time-lag to BV 0820-455.97
Output power (to DIN 45 324):
Battery operation: 2.5 W sine
Mains operation:
10 W sine
15 W music power
Battery Life
(to DIN 45314)
with Varta 4020:
AM approx. 80 hours
FM approx. 78 hours
with Varta 3020 ;
AM approx. 45 hours
FM approx. 44 hours.
Tuned circuits:
FM: 7 (4 tunable) +2 ceramic filters
AM: 11 (3 tunable) +1 ceramic filter
AGC:
AM: 3 stages
20
Tone control:
Separate bass and treble, continuously
variable
Loudspeakers:
Permanent-magnet dynamic Superphon
loudspeaker with hi-flux magnet, and
tweeter (both speakers switchabie).
Wavebands:
FM : 87.5-
108 MHz
LW:
148-
420 kHz (0.148 - 0.420 MHz)
MW: 510 — 1620 kHz (0.510 ~ 1.620 MHz)
SW:
1.6- 26.1 MHz
Receivable SW Bands
Band
Frequency
Centre
(MHz}
(MHz)
160m amateur
1.815-
1.890
1.855
120m radio
2.300-
2.498
2.400
90 m tropic
3.200-
3.400
3.300
80 mamateur
3.500-
3.800
3.650
75 m radio
3.900-
4.000
3.950
60 m tropic
4.750-
5,060
4.905
49 m radio
5.950-
6.200
6.075
41m radio
7.100-
7.300
7.200
40mamateur
7.000-
7.100
7.050
31 m radio
9.500~
9.775
9.635
25 m radio
11.700
~ 11.975
11.835
20mamateur
14.000- 14.350 14.175.
19 m radio
45.100
- 15.450
15.275
17mamateur
18.068
- 18.168
18.115
16 m radio
17.700 - 17.900
17.800
415m amateur
21.000
- 21.450
21.225
13 m radio
21.450
- 21.750
21.600
12mamateur
24.890 - 24.990
24.940
11m radio
25.600 ~ 26.100
25.850
Built-in aerials:
Telescopic aerial for VHF/FM and SW Fer-
rite rod aerial for LW and MW.
Aerial trimmer:
For external aerial on SW
Terminal clamps:
For extemal aeriat and earth
Connecting sockets:
Mains lead socket with battery-mains
switch
Head/earphone socket for 6.3 mm jack
plug (mono or stereo}
Socket for cassette/tape recorder or re-
cord deck: 7-pin standard socket (univer-
sal) Socket for external aerial (75 ohm
coaxial socket for all wavebands)
Phono LINE (IN-OUT) socket.
Weight:
8.5 kg (without batteries)
Dimensions:
approx. 504x242 x202 mm (WxHxD)
(depth including handles for front panel).
Subject to technical alterations and altera-
tions in styling.
Important
The set should only be cleaned with a
soft, anti-static cloth.
Do not use aggressive polishes or clean-
ing agents.
a
Note
This set should not be exposed to a tem-
perature higher than 60° C. Remember
that this temperature may well be ex-
ceeded on the rear shelf in a car in strong
sunlight and serious damage may result.
Notes on type of unit will be found on
base of set.
Operation in Watercrafts and
Land Vehicles
The Satellit can be secured for mobile
operation.
For this two threaded holes, M4 are pro-
vided in the base. Leave enough
space at
the back so that the sockets and controls
remain accessible.
The screws M4 must be 13-15 mm longer
than the thickness of the material on
which the Satellit is fixed.
Advertisement
