Pioneer DC-888Z Operating Instructions Manual page 9

FRONT PANEL FACILITIES
Tuner: TX-888Z/TX-888ZL
| FM MONO switch/indicator
Normally this is set to the off position (the FM MONO
indicator goes off). When noise spoils the reception of an FM
program, press the switch to the on position (the FM MONO
indicator will now light).
The program of an FM stereo broadcast will be heard in mono.
The setting of the FM MONO switch (on or off) is memorized
along with the station's frequency in the STATION CALL
switches. i
When using the preset tuning feature, reception will be in the |
mode selected when the station was memorized.
This switch will not function for AM (MW or LW) reception. |
SELECT (1-12/13-24) switch/indicator
This switch is used to set the STATION CALL switches to either Mode 1
{Stations 1—12) or Mode 2 (Stations 13-24). To put the unit in Mode 2,
press this switch. The indicator is lit up during Mode 2.
NOTE:
Changing the position of this switch has no effect on tuner per-
formance itself.
FREQUENCY display
Permits reading the received frequency at a glance from the
dispiayed figure. The FM band is indicated by MHz, and the
AM (MW or LW) band by kHz.
TUNING switch
This is used to locate the stations.
Push either side of this switch; the left side "—" to go to a
lower, and the right side "+" to go to a higher frequency.
STEREO indicator
This lights when a stereo program has been picked up during
an FM broadcast.
TUNED indicator
This lights to indicate when the finest tuning of a station has
been achieved.
STATION CALL switches
These are used to recall preset broadcasting stations and to
preset the station.
MEMORY switch
This switch is used to memorize stations. When the switch is
pressed, the frequency display will flash. To memorize the frequency |
of any station, press the STATION CALL switch while the frequency |
display is flashing.
BAND SELECTOR switch 8,
[For model TX-888Z] wa
Each time this switch is pressed, FM or AM reception is
selected alternately.
FM and MHz light: FM reception
AM and kHz light: AM reception
[For modei TX-888ZL]
Each time this switch is pressed, FM, MW or LW recep-
tion is selected alternately.
FM and MHz light: FM reception
AM and kHz light: MW or LW reception
9
<ARB1072>