Pioneer DC-888Z Operating Instructions Manual page 22

Cassette Deck/Amp
Symptom
Cause
No sound from speakers.
® Is volume level turned down?
® MIC MIXING control is at MIC side.
Tape deck will not work.
i ® Is deck in pause mode?
® Is tape loaded correctly?
® Load correctly
@ Is a blank tape loaded?
® Are heads clean?
® Set FUNCTION switch to TAPE.
® Load a pre-recorded tape.
@Clean heads. =
Recording not possible.
® is tape loaded in Deck |?
® Are heads clean?
@ Is cassette tab broken?
® Load blank in Deck 1 for recording
® Clean heads
@ Apply ¢ over tab hole, (See page 12.)
High frequency sounds not
reproduced.
@ Are heads clean?
® Clean head:
® Turn off the Dolby NR system
High frequencies
over-emphasized.
® Turn on the Dolby NR system
®@ Is power to TV set turned on?
® Is unit located too close to TV set?
® Move unit at least 30 cm from TV set.
Stereo Tuner
No sound
except TUNER.
® Set FUNCTION switch to TUNER
® fs loop antenna connected?
® Is band selector swich set to AM (LW or MW)?
® Is station tuned in properly?
® Connect loop antenna.
® Set band selector swich to AM (LW or MW),
L
FM reception not possible
® Is antenna connected?
: aie
® Connect
antenna,
following
instructions
on
page 6.
® Set band selector switch to FM,"
Large amount of noise
® Switch OFF the CD player.
Turntable
Turntable does not work.
® Attach belt correctly.
No sound.
® Set FUNCTION switch to PHONO.
Static, scratching noise
produced,
® Is record surface dirty?
® Is record warped or scratched?
® Clean record.
® Replace record.
Stylus does not descend
at correct position.
({PL-888Z only)
| ®@ Is record a special size?
22
<ARB1072>