Pioneer DC-888Z Operating Instructions Manual page 5

CONNECTIONS
Proceed as follows with the set-up and connections.
® When using the rack, connect the AM and FM antennas be-
fore mounting in the rack. It can be difficult to connect the
antennas after mounting in the rack.
1. Connect the FM antenna and the AM antenna te the tuner's
| antenna terminals.
i 2. Connect the tuner's input/output cord to cassette tape
| deck amplifier.
| 3. Connect the turntable's cord to the cassette tape deck am-
plifier's jacks. If any other stereo componentis to be used,
connect it in the same way to the CD or VIDEO jacks.
4, Connect the speaker cords to the SPEAKERS terminals of
the cassette tape deck amplifier.
5. Finally, connect the power cord of the cassette tape deck |
amplifier to the AC wall socket or audio timer (AC OUTLET).
Plug the power cord into the AC wail socket outlet only after all
the connections have been completed. Keep the power switch at)
the OFF position.
When using
anather turntable
Turntable
When using
PL.888Z oF
PL-777Z turntables.
left and right claws.
Speaker (Right)
system
(Left)
Compact disc player
fe
llustration not applicable to U.K. model.
To AC
wail socket
Insert the connector obliquely from above, and
push it down unti it locks, thus ensuring that it is
connected. When disconnecting the connector
pull it in the opposite direction while pressing the
Connecting the input/output cords
® Insert the plugs securely into the jacks. Improper con-
nection can lead to sound distortion or malfunctioning.
® The white plug is for the left channel connection and
the red plug for the right channel connection.
Be sure to insert the plugs all the way.
White piug
Cts
i
i Red plug
R @=at
fe sas
Connecting the speaker cords
fi] Cutter
2 \ Speaker cord € -
Twist the strands,
3) 10 mm 4)
=
Speaker hy
cord Push down Push up
ake
® Connect the cord to the speaker terminals, making sure not
to reverse the ® and © connections.
® Check that the speaker cords are secure and will not be-
come disconnected.
NOTE:
Do not allow the conductors of the cords to project beyond the ter-
minals and to come into contact with other conductors, A
breakdown or failure may occur when conductors touch one
another.
Speaker impedance
Connect speaker systems with a nominal impedance of bet-
ween 6 and 16 ohms.
5
<ARB1072>