Table of Contents
Advertisement
In any case, however, shipping charges and cus¬
toms clearance fees are to be borne by the
sender. To prove the date of your purchase
when required, please keep the receipts or bills
covering the purchase of your equipment for at
least a year. Before sending your equipment for
servicing, please make sure that you are send¬
ing it to the manufacture's authorized represen¬
tatives or their approved repair shops, unless
you are sending it directly to the manufacturer.
Always obtain a quotation for the service
charge, and only after you accept the quoted
service charge, instruct the service station to
proceed with the servicing.
The local warranty polici^ available from
Pentax distributors in some countries can su¬
persede this warranty policy. Therefore, we rec¬
ommend that you review the warranty card
supplied with your product at the time of pur¬
chase, or contact the PENTAX distributor in
your country for more information and to re¬
ceive a copy of the warranty policy.
STATEMENT OF FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions : (1) This device may not
cause harmful interference, and (2) this device must accept any inter¬
ference received, including interference that may cause undesired op
eration.
Changes or modifications not approved by the party responsible for
compliance could void the user's authority to operate the equipment
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment gen¬
erates, uses and can radiate radio frequency energy and, if not in¬
stalled and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi¬
sion reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one
or more of the following measures :
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
The CE Mark is a Directive conformity mark of the
European Community.
33
Advertisement
Table of Contents
