Table of Contents
Advertisement
TROUBLESHOOTING
Symptom
Probable Cause
POWER
Cannot turn power on.
© The power plug is removed.
e The component
(stereo amplifier, audio
timer, etc.) to which the power cord is
connected is off.
CASSETTE DOOR
The door does not open.
—______1_____
Remedy
|
* Insert the power plug correctly.
® Turn the stereo amplifier or audio timer on.
a
e The deck is not in stop mode
(tape is
moving).
* Press the stop ( J ) button.
The door does not close.
The cassette is not properly loaded.
|_ PLAYBACK
Reinsert the cassette.
Immediately stops.
The level meter does not
work.
No sound
® The tape is completely wound.
¢ The tape is slack.
¢ The tape is not recorded.
* The tape head is dirty.
© The amplifier input selector is not correctly
set.
* The amplifier volume level setting is too
low.
¢ Connection problems (wrong connection,
cord removed, poor contact, broken wire).
° Play back in the opposite direction.
¢ Rewind the tape.
* Take up tape slack (see page 11).
e Replace the tape with a recorded one,
* Clean the head (see page 17).
¢ Set the amplifier input selector correctly.
¢ Turn the amplifier volume control up.
* Connect securely.
RECORDING
The recording indicator does
not light up.
:
The cassette
erasure
prevention tabs are
broken.
¢ Replace the cassette with one whose tabs
are intact.
© Cover the hole under the tab (see page 1). |
The level meter does not
work.
* The REC LEVEL control is set too low.
¢ The amplifier is not delivering a recording
signal (from the tuner, CD player, etc.).
e Wrong
connection,
connection
cord
removed,
poor contact, broken wire.
e Turn the REC LEVEL control up.
© Set the amplifier recording output selector
correctly.
¢ Check connections.
Immediately stops.
¢ The tape is completely wound up.
© The tape is slack.
Cannot record
18
<RRB1I022>
e Record in the opposite direction.
e Rewind the tape.
© Take up tape slack (see page 11).
The head is dirty.
Clean the head (see page
17).
Advertisement
Table of Contents
