Table of Contents
Advertisement
TROUBLESHOOTING
Symptom
Probable Cause
Remedy
POWER
-
Cannot turn power on.
|
® The power plug is removed.
* The component
(stereo amplifier, audio
timer, etc.) to which the power cord is
connected is off.
® Insert the power plug correctly.
® Turn the stereo amplifier or audio timer on.
CASSETTE DOOR
The door does not open.
* The deck is not in stop mode
(tape is
moving).
—_{—
|
® Press the stop ( B® ) button.
The door does not close.
The cassette is not properly loaded.
Reinsert the cassette.
PLAYBACK
Immediately stops.
® The tape is completely wound.
® The tape is slack.
® Play back in the opposite direction.
1 ® Rewind the tape.
@ Take up tape slack (see page 11).
The level meter does not
work,
© The tape is not recorded.
© The tape head is dirty.
® Replace the tape with a recorded one.
* Clean the head (see page 17).
The recording indicator does
not light up.
The cassette erasure prevention tabs are
broken.
® Replace the cassette with one
are intact.
a
%
* Cover the hole under the tab (see page
11).
i
The level meter does not
work.
i
® The REC LEVEL control is set too low.
* The amplifier is not delivering a recording
signal (from the tuner, CD player, etc.).
2 Wrong
connection,
connection
cord
removed, poor contact, broken wire.
® Turn the REC LEVEL control up.
| * Set the amplifier recording output selector
|
correctly.
® Check connections.
immediately stops.
® The tape is completely wound up.
© The tape is slack.
® Record in the opposite direction.
* Rewind the tape.
| ® Take up tape slack (see page 11).
18
<RRB1031>
Cannot record
The head is dirty.
Clean the head (see page 17).
Advertisement
Table of Contents
