Komatsu GD555-5 Operation & Maintenance Manual page 226

OPERATION
The machine can be lifted only if it has hook mark labels.
When lifting the machine, stop the machine on level ground and do as follows.
1. Start the engine, make sure that the machine is horizontal,
then set the work equipment to the travel posture.
2. Stop the engine, confirm the safety around the operator's seat,
and then lock by using the articulation lock pin to prevent the
front frame and rear frame from articulating.
3. Use wire ropes and slings that match the weight of the machine, and wind the wire rope and fix it to the lifting
points as shown in the figure.
NOTICE
Use protectors, etc. so that the wire ropes will not be broken at sharp edges or narrow places.
Use spreaders and bars having sufficient width so that they will not touch the machine.
4. Before lifting up the machine, set the slings and float the machine to 100 to 200 mm (3.9 to 7.9 in) above the
ground. Make sure that the wire ropes are not slack and the machine is kept horizontally, and then lift up the
machine slowly.
TRANSPORTATION
3 - 173